10' Wall Canopy Hood, Fan, Direct Fired Heated Makeup Air Unit System

Description

This powerful package includes a handsome Hood, an efficient Exhaust fan and a hefty Heated Make Up Air Unit.  And did someone say "free roof curbs"?
10' long exhaust-only wall canopy hood with front perforated supply plenum with built-in 3" back standoff.
430 SS Where Exposed
54" depth provides better capture and containment of cooking vapors at lower airflow volumes.
600 degree hood rating - allows use with medium to heavy duty cooking equipment providing ultimate flexibility.
16" tall x 20" wide Kleen-Gard Stainless Steel Baffle Filter with Handles and Bottom Hanging Hook, UL Classified
Incandescent Light Fixture-High Temp Assembly, Includes Clear Thermal and Shock Resistant Globe (L55 Fixture), Bulbs By Others
EXHAUST RISER - Factory installed 16" Diameter
SUPPLY RISER - 12"x 24" Supply Riser with Volume Dampers
1/2 Pint Grease Cup New Style, Flanged Slotted
High Speed Direct Drive Centrifugal Upblast Exhaust Fan with speed control (single phase only), disconnect switch and 15-3/4" wheel.
Exhaust Fan handles 2250 CFM @ -0.750" wc ESP, Fan runs at 1302 RPM
Exhaust Motor: 0.750 HP, 1 Phase 115 V, 60Hz, 13.0 FLA, ODP (Open Drip Proof)
Grease Cup for kitchen-duty centrifugal exhaust fans, Box Dimensions 15-3/4 L X 5-1/16 W X 3-3/4 H (18 GA.) (Includes Down Spout)
Curb CRB23X20E On Fan # 1 Flat Curb
Hinged Base for Curb. Standard Hinge attached to curb. Used on Fans with wheels 20 inches or smaller. 12 GA Galvanized
Vented Base for Curb
Direct Gas Fired Heated Make Up Air Unit with 10" Blower.
Supply Fan handles 1800 CFM @ 0.500" wc ESP, Fan runs at 983 RPM
Heater supplies 110484 BTUs. 55°F Temperature Rise. [Fuel: Natural Gas]
Supply Motor: 1.000 HP, 1 Phase 115 V, 60Hz, 14.0 FLA, ODP (Open Drip Proof)
Down Discharge - Air Flow Right -> Left
Sloped Filtered Intake for Size #1 Modular Heater. 21.813" Wide x 44.375" Long x 23.375" High. Includes 2" MV EZ Kleen Metal Mesh Filters
RTC Solutions • 40-90°F Discharge Temp Control
Gas Manifold for DF1 GM - BTU 0 - 550001 - 7 in. w.c. - 14 in. w.c., No Insurance Requirement (ANSI), BV250-66
Motorized Back Draft Damper 16" X 18" for Size 1 Standard & Modular Direct Fired Heaters w/Extended Shaft, Standard Galvanized Construction, 3/4" Rear Flange, LF120S Actuator Included
Low Fire Start. Allows the burner circuit to energize when the modulation control is in a low fire position
Gas Pressure Gauge, 0-35", 2.5" Diameter, 1/4" Thread Size
Gas Pressure Gauge, -5 to +15 Inches Wc., 2.5" Diameter, 1/4" Thread Size
Curb CRB21X71X20INS Insulated On Fan # 2 Flat Curb